| RWA
Firmware Release Notes: |
- Firmware
2.41 / NMS 1.1.20
- ADDED
- FIXED
- DHCP relay operation on IXP platforms.
- Encryption (WEP-WPA-WPA2) firmware bug.
- 900Mhz-2.4Ghz-4Ghz-5Ghz interoperability issues.
- GUI-NAT issues with more than 60 NAT entries.
- Firmware
2.40 / NMS 1.1.9
- ADDED
- VAPs (Multiple SSIDs)
- India Country code
- New web page (RWA CPE)
- Fixed
- Channel bandwidth for 802.11G and 900Mhz
- WDS association list
- WPA issue with multiple BSSIDs
- Power Issue on 5000 units with differnet radio types
- Firmware
2.3.6 / NMS 1.1.8
- ADDED
- Shared Key
Authentication Support
- Minimal Web
Configuration support for CPE
- Firmware
2.3.4 / NMS 1.1.6
- ADDED
- Network
tuning (timeouts, max number of connections etc), located
under "System Properties"
-
802.11 MIB, including association list
-
Italy Country Code
- FIXED
-
Wireless: Inactivity (AP - Station keep alive packets)
- Hide
SSID (Station mode)
- RWA
CPE, WPA: CCMP encryption
-
WPA: 802.1x servers (not saved in configuration properly)
-
RWA 5000, Ethernet Roaming Problem
- Firmware
2.3.2 / NMS 1.1.4
- FIXED
-
Added RIP for RWA 3000 and 5000 series
-
Added ping watchdog service
-
900Mhz site survey display fix
-
AP Client/Station inactivity problem fix
-
Fixed Hide SSID problem
- RWA
CPE Country code fix
-
RWA CPE QoS fix
- Firmware
2.3.0
- FIXED
- 802.11
signal level (Major fix)
-
AP client issue (ARP resolution)
-
Second WDS interface issue
-
Wisp Easy Wizard issue
-
Hotspot issue (configuring more than 1 wireless interfaces
issue)
-
Hotspot on RWA 5000 (ssl, hotspot image)
- Hotspot
redirection issue (some pages would not work for redirect)
- NAT
issue RWA CPE
- Outdoor
link performance tweaking
- Pure
G mode enhanced
- Firmware
2.2.7
- FIXED
- WEP
fix
-
DFS fix
-
Added cpu usage meter
-
Added temperature and voltage meter for RWA 5000 series
- Firmware
2.2.6
- FIXED
- Wireless
routing bug
- Open
connections crash
- Firmware
2.2.5
- ADDED
- Additional
monitoring for Client-Station of Tx Rate real time value
- FIXED
- W2W
issue with multiple AP's existence in same base node fixed.
-
900Mhz frequency tweaking
-
WDS association list now includes information for WDS
Registered MACs
-
Mismatch for Distance value fixed for disabled interfaces
-
eXtended Range capability adjusted to be 100% functional
with every RegDomain
-
Save configuration with XR enabled fixed
- Firmware
2.2.4
- ADDED
-
900MHz support
-
New wireless driver
- TX
power override
-
Compression
-
DFS/TPC "802.11h" full support
- Adaptive
Radio Technology "AR" support
-
Repeater Mode WPA-PSK supported
-
PureG mode support
-
EAP Accounting and Secondary Servers
- FIXED
- Tx
power
-
Rx Sensitivity
-
Antenna Selection
-
High Power Cards Regulation
-
5/10 MHz channel bandwidth allocation
-
Country Code All -> "2.312-2.732 GHz, 4900-6100
GHz"
-
Turbo A
-
Turbo G
-
WPA AES Mode
-
XR support
-
WMM Configuration
-
WDS Operational Mode
-
Repeater Operational Mode
-
Atheros VLAN "802.1q" Pass through
- Performance
Optimization
-
Site Survey in AP mode
-
Inactive Stations storage after save
- ACL
limitation ->from 50 nodes moved to 200 nodes
-
System date configuration
-
Service's status -> snmp, http, ssh,ntp, dhcp
-
Hotspot VPN pass through
-
Hotspot WAN'S bandwidth utilization
-
DHCP leases
-
DHCP Relay
- Firmware
2.1.2
- ADDED
- Hotspot
external redirection support
-
Short/long preamble support
-
High power cards tx-power auto adjustment
-
Resizable Site Survey and Assoc List
-
Load last saved Profile
-
Remember username/password for Live Unlock
- FIXED
-
Hotspot DHCP IP pool fix (only x.x.x.1/x was valid before)
- Hotspot
dns2 fix
- WMM
fix
- WEW
fix
- IRELAND
Country Code included
- Antenna
selection fix
- Qos
40 classes limitation fixed.#Firmware 2.1.0ADDED- Super
A/G (Fast Frames, Bursting) Support
- TurboA/TurboG
108 Mbps Support
- Special
Country Code "all": 2312 - 2732 Ghz , 4920 - 6100
Ghz
- TPC/DFS
Minor Support
- QoS
(Quality of Service) on Layer3
- DHCP
relay
- Bug
Fixes and Optimization
- Firmware
2.1.1
- FIXED
- Bug
Fixes and Optimization
- Firmware
2.1.0
- ADDED
- Super
A/G (Fast Frames, Bursting) Support
-
TurboA/TurboG 108 Mbps Support
-
Special Country Code "all": 2312 - 2732 Ghz
, 4920 - 6100 Ghz
-
TPC/DFS Minor Support
-
QoS (Quality of Service) on Layer3
-
DHCP relay
- Firmware
1.1.2
- FIXED
- TX
Antenna Configuration
-
Country Code Issue
- Firmware
1.1.1
- ADDED
-
DHCP client hostname support
- FIXED
-
Key generation compatibility
- Saved
wireless settings mismatch fixed
- Association
list deny command fixed
- ACL
manipulation fixed
- Console
utility update
- Firmware
1.1.0
- ADDED
- Enhanced
Association List
- Alias
configurable attribute
-
Inactive Stations included (Idle Time attribute)
-
Link parameters available (Signal,Noise,Fade Margin,Rate)
-
command set availability (Remove from list,Disassociate,Ban)
-
Wisp Easy Wizard
-
Monitor Utilities
- VLAN-802.1Q
support
-
Atheros net-snmp MIBs included
- FIXED
- Changed
hotspot's access request message (attribute username)
(in case of mac address authentication) to comply with
rfc's hotspot administrator's mac is always authenticated
fixed image alignment issue
- Site
Survey improved performance
-
TxPower regulation for Atheros Cards fixed
-
Repeater recover after losing link with AP fixed (Repeater
Link Keep Alive Proc)
-
Access Point's address 4 Clients manipulation improvement
-
Fast Antenna Diversity fixed
-
WPA supplicant handshake procedure improvement
-
WPA Group Key update procedure fixed
-
Auto Rate Fallback for WDS links fixed
-
Wireless Statistics mismatch for high values fixed
- WDS
MAC list initialization and maintenance improvement
-
WDS nodes included in Association List among with Link
attributes
- Firmware
1.0.1
|
| |
|